Testimonials

May 3, 2004

I had the oil changed in my Dodge Neon and put the Polycoat in with the fresh oil. I put the Polycoat in it on Saturday and drove about 50 miles. The car has about 52,000 miles on it. It is my work car as I drive to Washington DC everyday from our home in Waldorf, Maryland. It is about a 60 mile roundtrip. The car normally sits in the garage and is not driven on Saturday and Sunday. When I go back to work on Monday morning the first thing that usually happens is that the engines makes noise for about 10 seconds until the oil works its way up into the valves. It has done that since I bought the car new in 2000. As soon as the oil gets lubricating it quiets right down. It has always concerned me because I knew that noise was metal to metal and had to cause wear and tear.

Well this morning I started the car and no "Noise". It was quiet the whole time. No waiting for the oil to work its way up from the oil pan. I am not a mechanic and don't need to check the compression. I am happy hearing the results that Polycoat has shown me. I really have not got it completely worked in the engine yet either.

I wanted to let you know what a distinct difference that Polycoat made on my initial startup after the engines has sit idle. The only way that it could be quiet like that is if oil is sticking to the metal parts as your product promised it would.

Thanks and I will keep you informed. Warm Regards. Satisfied Customer,

Greg Schroeder,
Waldorf, Maryland

September 25, 2002

The following is an unsolicited testimonial for Polycoat 20-HWE from a very satisfied customer and may be posted on the Internet or included in any literature distributed about this product.

It's amazing that more people don't know about this oil lubricant. Perhaps because other additives did not perform as well, but this new product is incredible!

I noticed the effect of applying 20-HWE right away. My engine runs quieter and my car's emissions have been noticeably reduced. I keep track of my car's mileage and I have noticed an improvement of about 10 to 15 miles per tank.

I expect to experience increased savings on my yearly expenses on gas and this alone is worth the cost of Polycoat 20-HWE. I highly recommend this very useful product.

James R. Moulton

August 19, 2002

Michael

I have conducted two compression tests for Polycoat, LLC on a Toyota Corolla 2002. The first test made on July 29, 2002 before the addition of Polycoat 20-HWE, showed the following compression results: cylinder #1 (175 psi), cylinder #2 (181 psi), cylinder #3 (176 psi), cylinder #4 (178 psi). On August 13, 2002 after the vehicle covered 750 miles, another compression test was made.

This time the following results were obtained: cylinder #1 (185 psi), cylinder #2 (190 psi), cylinder #3 (184 psi), cylinder #4 (187 psi). These test results indicate a considerable compression increase inside the engine (4.6% on average). I personally performed these tests and was impressed by these results.

A few days later I purchased two bottles of Polycoat 20-HWE and added one bottle to the engine oil and another one to the transmission fluid inside my wife's Mercedes. I believe this product has a major potential on the US market and I've decided to distribute it through my own car shop.

Michael,
Owner,
Advanced Autohaus, Ltd.
5335 Leetsdale Dr., Denver, CO 80222
Ph. (303) 336-0971
Fax (303) 336-0972